DataCard SR200

96 Error Recovery and Messages
Jam(MG) Thereisacardjaminthe
magneticstripeencode
section.
1. Pre ssResetandthentoinitializethe
printer.
2. Ifnocardisdischarged,removethecard
fromtheencodesection.
3. Pre ssResetandthentoinitializethe
printer.
Jam(Transfer) Thereisacardjaminthe
cardfeedrollers.
1. Removethejammedcard.
2. Pre ssResetandthentoinitializethe
printer.
3. Referto“ClearingaTransferJam”on
page 87.
Jam(Discharge) Thereisacardjaminthe
carddischargesection.
1. Pre ssResetandthentoinitializethe
printer.
2. Removethejammedcardfromtheretransfer
section.
3. Makesurethatthecardstackerissecurely
attachedtothestackerreceptacle.An
incorrectlymountedcardstack ercancause
dischargejams.
Jam(Retrans) Thereisacardjamnear
theretransferrollers.
1. Removethejammedcardfromtheretransfer
section.
2. Pre ssResetandthentoinitializethe
printer.
3. Referto“ClearingaRetransferSectionJam”
onpage 89.
FilmSearch Theretransferfilmis
brokenormissing.
1. Repairtheretransferfilmasdescribedin
“MendingaBrokenInkRibbonorRetransfer
Film”onpage 90.
2. Pre ssReset,Next,andthento
initializeandadvancethefilmbyonepanel.
FilmRunOut Theretransferfilmhas
runout.
1. Loadanewrollofretransferfilmasdescribed
in“LoadingRetransferFilm”onpage 16.
2. Initializethenewrolloffilmasdescribedin
“InitializingtheInkRibbonandRetransfer
Film”onpage 22.
PrinterLCDMessage PossibleCause Solution