DataCard SR200

40 Printer and Laminator Settings
Closing the Status Monitor
ToclosetheStatusMonitor:
1. ClicktheredClosebutton.
2. Apromptdisplays,askingifyouwanttoclosetheStatusMonitor.ClickYes.
TipsforSuccess
 WhenyouclosetheStatusMonitor,communicationbetweentheprinterand
driverbecomesoneway,withtheprinterdriversendingcardstotheprinter.
 TokeeptheStatusMonitorrunningwithoutviewingit,clickMinimize.
Printer Status Tab
ThePrinterStatustabdisplays:
 Thetypeofinkribbonandtheapproximatepercentage
remaining.
 Thetypeofretr ansferfilmandtheapproximate
percentageremaining.
 TheprintcounterandaClearbuttontoresetittozero.
 Theprintername.Ifmorethanoneprinterisinstalled,
selecttheprintertoworkwithusingthePrinterSelection
list.ClickUpdatetosearchforadditionalSR200&SR300
printers.TheinformationdisplayedontheStatusMonitor
changesautomaticallywhenyouselectanotherprinter:
 IfthePCisnetwork‐connected,onlyprintersonthe
samesubnetasthePCcanbefound.
 IfthePCisUSB‐connected,allprintersconnectedtothePCwillbefound.
 CardQuantity:Enoughisdisplayedwhencardsarepresentinthehopper.Nonedisplays
whennocardsarepresent.
 Iftheprinterisprocessingajob,thenameofthedocumentandthenameof
theuserdisplaysintheDocumentInformationarea.
 Whentheprinterrequirescleaning,theprinterimagedisplaysCleaning:
 Ifalaminatorisattached,laminatorstatusdisplaysundertheprinterstatus
(markedbytherectangle).
 Thecurrentstateoftheprinter,suchasReady. Theiconchangescolorwithdifferentstates.
Refertothefollowingtable: