DataCard SR200

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 79
Preparing the Printer and Laminator for Transport
Usesavedpackagingmaterialstopreparetheprinterandlaminatorfortransport.Transport
includesmovingtheprinterfromonelocationtoanotherwithinthesamefacility.
1. Openthedoortotheprinter.TheDoorOpenerrormessageis
displayed.
2. Removetheprinterinkribboncartridgeandremovetheinkribbon
from
thecartridge.Replacetheemptycartridgeintotheprinter.
3. Removetheretransferfilmcartridgeandremovetheretransferfilmfromthecartridge.
Replacetheemptycartridgeintotheprinter.
4. Ifthereisalaminator,openthelaminatordoorandremovethetopandbottomlaminate
cartridges.Removethepatchor
topcoatmaterialandreplacetheemptycartridgesintothe
laminator.
5. Closethedoorstotheprinterandlaminator.PresstheResetkey .
6. TheInitializeOK?messagedisplays.Pressthekey .
7. TheFilmSearcherrormessageisdisplayed.
8. SettheprintertotransportmodeusingtheLCDpanel.Referto
“TransportMode”
onpage 55forinstructions.
9. Powerofftheprinterandlaminator.
10. Disconnectthepoweranddatacablesfromtheprinterandlaminator.
11. Removecardsfromthehopper.
12. Removetheoutputstack er.
13. Allowtheunittocooldownbef orepackagingitfortransport.
14. Packagetheprinterandlaminatorintheiroriginalshipping
cartons.
Whentheprinterisnotinuse,poweritoffandcovertheprinterwiththeplastic
shippingbagtokeepdustandotherdebrisoutoftheprinter.