DataCard SR200

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 89
16. Replacetheinkribboncartridgeandinitializethesuppliesasdescribedin“InitializingtheInk
RibbonandRetransferFilm”onpage 22.
Clearing a Retransfer Section Jam
Ifacardjamsintheretransfersection,Jam(Retransfer)isdisplayedontheLCDpanel.Toremove
thejammedcard:
1. Powerofftheprinter.
2. Opentheprinterdoor.
3. Presstheretransferfilmcartridgereleasebuttonandremovetheretransferfilmcartridge.
Thecardmightbestucktothefilm.Watch
carefullytoavoidjamming
thecardwhenremovingtheretransferfi lmcartridge.
IfyoupoweruptheprinterandthePleaseCloseDoordisplays,the
retransferfilmcartridgeisstuck.Pushitbackintotheprinter,close the
door,andreturntostep2.
4. Removethecardfromtheprinteror
fromtheretransferfilmcartridge.
5. Ifthecardisstucktotherightoftheheatroller,referto“Clearinga
TransferJam”onpage 87.
6. Ifthecardisstuckneartheretransferheatroller,usethe
suppliedtweezerstoremovethecard,asshown.
7. Replacetheretransferfilmcartridge
andclosetheprinter
door.
8. Powerontheprinter.
9. PressReset.CardJamRemoved?displaysontheprinter
LCDpanel.
 PressYesonlyifthecardisremoved.
 PressNoifthecardremainsinsidetheprinter.
10. Initializethesupplies.Referto“InitializingtheInkRibbonandRetransferFilm”onpage 22.
Iftheerrorstilloccurs,thenacardisstilljammedintheprintersomewhere.
Caution: Do not initialize the printer with the card
inside.