DataCard SR200 User Manual

A-8 Status Monitor Messages
05000055 Top‐sidefi lmisbrokenorisnot
detected.
 Makesurethatthatthelaminatefilmis
correctlyset.
 Makesurethatthatthetypeoflaminate
filminuseandthesettingsare
appropriate.
05000056 Bottom‐sidefilmisbrokenorisnot
detected.
 Makesurethatthatthelaminatefilmis
correctlyset.
 Makesurethatthatthetypeoflaminate
filminuseandthesettingsare
appropriate.
05000057 Markontop‐sidefilmisnot
detected.
 Makesurethatthatthelaminatefilmis
correctlyset.
05000058 Markonbottom‐sidefilmisnot
detected.
 Makesurethatthatthelaminatefilmis
correctlyset.
05000059 Thelaminatordoorisopen.
 Closethelaminatordoor.
0500005A Thefilmcartridgeisdetached.
 Insertthefilmcartridge.
05000060 Thermostatisbroken.
 Powertheprinteroffandthenpoweriton
again.Ifthesameproblemoccurs,consult
anauthorizeddealerorservicepersonnel.
05000061 Thetemperatureofthetop‐side
heatrolleristoohigh.
05000062 Thetemperatureofthebottom‐side
heatrolleristoohigh.
05000063 Theinternaltemperatureofthe
top‐sideheater
istoohigh.
05000064 Theinternaltemperatureofthe
bottom‐sideheateristoohigh.
05000065 Ahardwareerrorhasoccurredin
thetop‐sideheatroller.
05000066 Ahardwareerrorhasoccurredin
thebottom‐sideheatroller.
ErrorCode DisplayedMessage Solution

DataCard SR200 Specifications

General

Brand	DataCard
Model	SR200
Category	Printer
Language	English