To Next Page

To Previous Page

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 67

8. TheMode(Back)menudisplaysnext.Toapplyanadditional

retransferlayertothebackofthecard,pressChange.

9. Pre ssthedownarrowkeyoncetochangeLine2toOnandthen

presstoacceptthechange.

Thesuccessoftheretransf ercanvarydependingonthecard

materialused.Youmayneedtoadjustthefrontandbackspeedof

retransfertogetanacceptablecard.

Loweringthespeedcanenhancetheretransfer,butthestrongerheatthatresultsmaycause

thecardtowarp.Increaseor

decreasethespeedvalues,asneeded,todeterminethebest

retransferresultsforyourcardtype.

 Tochangethespeedvalues,continuewithstep 10.

 Ifyoudonotwanttochangethespeedvalues,gotostep 16.

10. Pre ssNexttocontinue.

11. TheSpeed(Front)menudisplaysnext.Tochangethefrontspeed,

pressChange.

12. Pre ssthedownarrowtochangethespeedandthenpressto

acceptthechange.

13. Pre ssNexttocontinue.

14. TheSpeed(Back)menudisplays.Tochangethebackspeed,press

Change.

15. Pre ssthedownarrowtochangethespeedandthenpressto

acceptthechange.

16. Pre ssExitthreetimestoreturntheprintertoReadystatus.

17. Printseveraltestcardstotestyoursettingsandverifythatthe

retransferfilmisbeingappliedproperly. Continuetoadjustthe

settingsuntilyouaresatisfiedwithyourcards.

DataCard SR200 User Manual

Other manuals for DataCard SR200