DataCard SR300

14 Installing the Hardware Components
3. IfyoursystemincludesanLM200orLM300laminator,plugtheprovidedpowercordintothe
backofthelaminator.
4. Plugthepowercord(s)intothefacilitypowersource.
5. Ifthisisthefirsttimeyouareusingtheprinter,powerontheprinterandlaminatorwithout
installingsupplies.Keepthepoweronforabout 30seconds,untilaninkerrororafilmerror
occurs,thenpoweroff.
(Theprinter
andoptionallaminatorareshippedintransportmode.Inkribbonandretransfer
material,andlaminatormaterialcannotbeinstalledintransportmode.Poweroncancels
transportmodeandallowssuppliestobeinstalled.)
Connecting the Data Cable
ConnecttheUSBornetworkdatacableonlywhentheprinterdriverinstallationinstructionstell
youtodosoinChapter4orChapter6.
Iftheprinterhasbeenusedpreviously,thetypeofconnectiondisplaysontheprinterLCDpanel
whentheprinterispoweredon:
 TheUSBsymbolis:
 Thenetwork(LAN)symbolis:
ThedefaulttypeofconnectionisNetwork.Tosetotherconnectionvalues,referto“Settingthe
UnitNumber,PrinterName,andConnection”onpage 59.
For best results, connect only one data cable to the printer and PC before powering on the
printer.