DataCard SR300

SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide 63
Chapter 6: Network
Installation
Usethischaptertoinstalltheprinterdriverandconfigurethecard
printeronyournetwork,ifanetworkconnectionisbeingusedtoprint
cards.
About Network Installation
Wheninstallingtheprinteroveranetworkyoucanmakethefollowingchoices:
 UseDHCPorstaticaddressing
SetthischoiceusingtheStatusMonitor.Itdoesnotaffecttheprocedureyouusetoinstallthe
printer.Referto“ChoosingHowtoAssigntheNetworkAddress”onpage 64forinformation
aboutthechoices.
 UseIPv4orIPv6addressing
Theprintersupportsinternetprotocol(IP)addressingusingthetypicalv4format,suchas
123.123.123.123(32bits).ItalsosupportsthenewerIPv6standard,whichuses128bits.
Selecttheformatusedbyotherdevicesonyournetwork.
 Useauniqueprintername
YoucanassignanetworkprinternamesuchasPRINTER01orPRINTER09.Atthesametime
thatyouassignanetworkprintername,settheUnitNo(unitnumber)toacorresponding
value.Forexample,iftheUnitNoisU2,thenthenetworkprintername
mustbePRINTER02.
Referto“SettingtheUnitNumber,PrinterName,andConnection”onpage 59.
Iftheprinterhasbeenusedbeforethisinstallation,makesurethattheunitnumberand
networkprinternamecorrespond.
 UseIPSecsecurity
TouseIPSecsecurity,youmust:
a. Installtheprinter,driver,andStatusMonitorusingaUSBconnection.
b. Downloadfilesforsecurity.
c. RemovetheUSBdriverandStatusMonitor.
d. Installtheprinterasanetworkprinter.