To Next Page

To Previous Page

SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide 51

21. VerifyorchangethesettingsintheSR‐UPortdialogbox.

 OnthePropertytab,reviewtheinformation.Makesurethattheselectedportand

printerarecorrectforthisprinter.ClickOKtocontinue.

 IfthePrinterListdisplaysNoDevice,thePCmighthaveanetworkdriverrunningor

installed,ortheprintermightbesettouseanetwork(LAN)hostinterface.Followthese

steps:

i. RemovetheUSBcablefromtheprinter.

ii. ClickCancel.Adialogmessageconfirmsthatthedriverwas

notinstalled.

iii. ClickFinishtocloseinstallation.

iv. ChangetheHostInterfacesettingtoUSB.Referto“PrinterSelectTab”intheUser’ s

Guide.

v. Begindriverinstallationagain,startingwithstep 7.

22. ForWindowsVista,aWindowsSecuritydialogboxcandisplay.SelectInstallthisdriverto

continue.

DataCard SR300 Installation Guide

Other manuals for DataCard SR300