DataCard SR300

SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide 67
TosetupIPSecsecurityusingapresharedkey ,dothefollowing:
1. InstalltheStatusMonitorusingaUSBconnection.Referto“InstallingtheStatusMonitor”on
page 55forthestepstofollow.
2. Createakey .
a. UsinganapplicationsuchasNotepad,createatextfileforthekey .
 Allowedcharactersareupperandlowercaseletters(A–Z),numerals(0–9),andthe
specialcharactershyphen(‐),underscore(_),openandcloseparentheses(),period
(.),comma(,),andtheatsymbol(@).
 Thekeycanbeupto255characterslong.
b. Savethefilewithanextensionof“.key ”.
3. OpentheManagementConsolebyselectingStart>Run.EntermmcintheRundialogand
clickOK.Ifneeded,addtheIPSecurityPolicyManagementsnap‐in.
4. StartIPSecurityPolicyManagement.
ThisisavailableafterIPsecurityhasbeensetuponthe
PC.
5. OpentheEditAuthenticationMethodPropertiesdialogboxforthepolicy.
6. SelectUsethisstring:andenterthekeyfromstep1.
7. ClickOKtosavethevalueandclosethedialogbox.
8. ConnectthePCto
theprinterwithaUSBcable.
9. OpentheStatusMonitorasanadministrator.Refertothe“OpeningtheStatusMonitor”
sectionoftheUser’sGuide.
10. Powerontheprinter.Donotsendanycardstoprint.
11. ClickthePrinterSelecttab.Dothefollowing:
a. SelectIPSecEnable.Referto
the“PrinterSelectTab”sectionoftheUser’ sGuide.
b. SettheIPSecTypetoPresharedKey.
c. ClickDetails.TheIPSecsettingdialogboxopens.
d. SelectPresharedKeyfromtheDownloadTypelist.
e. ClickSelect.TheSelectCertificateDownloadFiledialogboxopens.
f. SelectPresharedKeyfromtheDownloadType
list.
g. SelectthefileandthenclickWrite.TheStatusMonitorsendsthefiletotheprinter.
12. RemovetheUSBcableconnectingtheprinterandPC.