CODE 39 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
143
Code 39 Set Length 2
This feature specifies one of the bar code lengths for "Code 39 Length Control" on page
142. Length 2 is the maximum label length if in Variable Length Mode, or the second
fixed length if in Fixed Length Mode. Length includes the bar code’s check, data, and
full-ASCII shift characters. The length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to ignore this
length (only one fixed length). See
"Set Length 2" on page 294 for more detailed pro-
gramming instructions.
Select Code 39 Set Length 2 Setting
$CC3L2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 2 = 50 (50 characters)
To Next Page
Loading...
Need help?
General
