AZTEC CODE ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
209
Aztec Code Set Length 1
Specifies one of the bar code lengths for "Aztec Code Length Control" on page 208.
Length 1 is the minimum label length if in Variable Length Mode, or the first fixed length
if in Fix
ed Length Mode. Characters can be set from 0001 to 3,832 characters in incre-
ments of 0001 (pad with zeroes).
See "
Set Length 1" on page 293 for detailed instructions on setting this feature.
Aztec Code Set Length 2
Specifies one of the bar code lengths for "Aztec Code Length Control" on page 208.
Length 2 is the minimum label length if in Variable Length Mode, or the first fixed length
if in Fix
ed Length Mode. Characters can be set from 0001 to 3,832 characters in incre-
ments of 0001 (pad with zeroes).
See "
Set Length 2" on page 294 for detailed instructions on setting this feature.
Select Aztec Code Length 1 Setting
$CAZL1
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left follo
wed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar
code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
0001 = Length 1 is 1 Character
Select Aztec Code Length 2 Setting
$CAZL2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left follo
wed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar
code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 2 is 3,832 Characters
To Next Page
Loading...
Need help?
General
