SETTING UP THE GRYPHON™ GBT/GM4500 READER
PRODUCT REFERENCE GUIDE
9
SETTING UP THE GRYPHON™ GBT/GM4500 READER
Follow the steps below to connect and get your reader up and communicating with its
host.
1. Configure the Base Station starting on page 14
2. Link to the Base Station on page 24
3. Select the Interface Type on page 26.
NOTE: According to recent modification of Regulation for shipping Li-Ion
based battery packs, the products and their spare battery packs parts are
shipped with a very low residual charge (low state of charge).
Hence the needs
* that a new product must be fully recharged before starting to use it.
and
* that battery packs of the stocked products GBT/GM45 and spare battery
pack parts must be periodically recharged: for instance by using a
WLC4090 base station powered up with a 12V Datalogic AC/DC adapter
(cod.8-0935) for at least 30 minutes each 3 months..
To Next Page
Loading...
Need help?
General
