SETUP
20
GRYPHON™ I GD/GBT/GM4500
REPLACING THE BATTERY PACK
Use the following procedure to change the reader’s battery:
1. With a narrow metallic object (i.e. a coin) or a screwdriver, unscrew the battery
cove
r screw.
2. Extract the battery pack from its slot.
NOTE: Before proceeding, read “Battery Safety” on page 2. To ensure max-
imum performance, Datalogic recommends the replacement of the
rechargeable battery pack if you note either of the following conditions:
• battery life drops below approximately 80% of the original life;
• battery charging time increases significantly.
To Next Page
Loading...
Need help?
General
