PRODUCT REFERENCE GUIDE
261
APPENDIX B
STANDARD DEFAULTS
The most common configuration settings are listed in the “Default” column of the table
below. Page references are also provided for feature descriptions and programming bar
codes for each parameter. A column has also been provided for recording of your pre
-
ferred default settings for these same configurable features.
Table 34 Standard Defaults
PARAMETERS DEFAULT
YOUR SETTING PAGE NUMBER
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore Obey 33
USB Suspend Mode Enable 33
RS-232 ONLY
Baud Rate 9600 35
Data Bits 8 Data Bits 36
Stop Bits 1 Stop Bit 36
Parity None 37
Handshaking Control RTS 38
RS-232/USB-COM
Intercharacter Delay No Delay 40
Beep On ASCII BEL Disable 41
Beep On Not on File Enable 41
ACK NAK Options Disable 42
ACK Character ‘ACK’ 43
NAK Character ‘NAK’ 43
ACK NAK Timeout Value 200 ms 44
ACK NAK Retry Count 3 Retries 43
ACK NAK Error Handling Ignore Errors Detected 45
To Next Page
Loading...
Need help?
General
