Datalogic Gryphon GD4200 - Global Prefix;Suffix

ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 81
Global Prefix/Suffix
Up to 20 ASCII characters may be added as a prefix (in a position before the bar code
data) and/or as a suffix (in a position following the bar code data). See
"Global Prefix/
Suffix" on page 232 for more detailed programming instructions.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at right followed by the digits from the Alphanumeric
characters in Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/
EXIT bar code again.
Set Global Prefix
$CLFPR
Set Global Suffix
$CLFSU
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

No Global Prefix

Global Suffix = 0x0D(CR)