Reading Parameters
30 Gryphon™ I GM44XX
Reading Parameters
Point the reader at the target and pull the trigger to enable the
aiming system and the illuminator (red beam) to capture and
decode the image. The aiming system will briefly switch off
during the acquisition time and if no code is decoded will
switch on again before the next acquisition. The illuminator
will remain on until the symbol is decoded.
As you read code symbols, adjust the distance at which you are
holding the reader.
Aiming System
A number of options for customizing control of the Aiming
System are available. See the PRG for more information and
programming bar codes.
To Next Page
Loading...
