LED and Beeper Indications
Quick Reference Guide 39
LED and Beeper Indications
The reader’s beeper sounds and its LED illuminates to indicate
various functions or errors on the reader. An optional “Green
Spot” also performs useful functions. The following tables list
these indications. One exception to the behaviors listed in the
tables is that the reader’s functions are programmable, and so
may or may not be turned on. For example, certain indications
such as the power-up beep can be disabled using programming
bar code labels.
Indication Description LED Beeper
Power-up
Beep
The reader is in the
process of powering-
up.
N/A
Reader beeps four
time
s at highest
frequency and vol-
ume upon power-
up.
Good Read
Beep
A label has been suc-
cessfully scanned by
the reader.
LED behavior for
this indication is
configurable via
the feature “Good
Read: When to
Indicate”
(see the PRG for
information.)
The reader will
beep once at cur-
rent frequency, vol-
ume, mono/bi-
tonal setting and
duration upon a
successful label
scan.
ROM Failure
There is an error in
the reader's soft-
ware/programming
Flashes
Reader sounds one
er
ror
beep at high-
est volume.
Limited Scan-
ning Label
Read
Indicates that a host
connection is not
established when the
IBM or USB interface
is enabled.
N/A
Reader 'chirps' six
tim
e
s at the high-
est frequency and
current volume.
Reader Active
Mode
The reader is active
and ready to scan.
The LED is lit
steadily
a
N/A
Reader
Dis
abled
The reader has been
disabled by the host.
The LED blinks con-
tinuously
N/A
To Next Page
Loading...
