Environmental Parameters regard the device Identity and Position in a Network (ID-NET™,
Master/Slave RS232, MUX 32, Ethernet) and are not influenced by the "Send Default
Configuration" and "Send Configuration" commands. This allows individual devices to be
configured differently without affecting their recognized position in the network.
The following is a list of the Environmental Parameters:
READING SYSTEM LAYOUT
- Device Network Setting
- Number of Slaves
DEVICE NETWORK SETTINGS
- Topology Role
- ID-NET Slave Address
- Network Baud Rate
- Acquisition Trigger String (available only in Multidata configuration)
- Reading Phase ON String (available only in Multidata configuration)
- Reading Phase OFF String (available only in Multidata configuration)
- Header String (available only in Slave Multidata configuration)
- Terminator String (available only in Slave Multidata configuration)
- Link Failure String (available only in Master Synchronized configuration)
- Link Failure Timeout (ms) (available only in Master Synchronized configuration)
EXPECTED SLAVE DEVICES
- Status
- Device Description
- Device Network Name
MAIN PORT
- Communication Protocol
- Multidrop Address
ETHERNET SYSTEM (on-board)
- Status
- DHCP Client
- IP Address
- Subnet Mask
- Gateway Address
- DNS1 Address
To Next Page
Loading...
Need help?
General
