List
To see a List of the current Backup:
1. Select "External Memory Read Backup" from the VisiSet™ Device menu.
The VisiSet™ Main window shows a list of devices in the current Backup.
The following is a list of possible error messages displayed on the VisiSet™ main window in
case of an External Memory function failure:
Module not present: backup module not mounted (BM100) or not ready (QL500,
BM2x0)
Unable to Read Backup State: VisiSet™ is unable to connect to the backup memory
Backup function not allowed: when device is in X-PRESS™ Menu mode (BM100,
QLM) or is out of memory (QL500)
Failed! (Device not found): Master is unable to reach the addressed device
Failed! (Module is write protected): BM100 Write Protection switch is set to Locked
To Next Page
Loading...
Need help?
General
