POWERSCAN® PD8530
3 INITIAL SETUP
This procedure allows setting up the reader to operate with the default settings.
Whenever you need to change the default values refer to par. 4.2.
3.1 RS-232 INTERFACE SELECTION
The PowerScan® PD8530 reader requires the RS-232 interface cable and the
AC/DC power adapter to be connected.
To install and configure your reader with the RS-232 interface, follow these
instructions:
Make all system connections as shown in Figure 3:
1.
Figure 3 - RS-232 Connection
Read the restore default parameter code below:
2.
Restore Default
AMHKGPAOFNGNENEIEPANHOGOCK
AHHPMBAMDKEOFMHMLJALECHGIK
AKCBPJCJGIIJCMCFGPLCMMMNLK
AEFBJLBGMHPKMOGNKKNDPDMGGK
AAPHBAJIDGHPOJKEFPNCEACBHK
AFKFBKNGLGMOMELLGOPCMJFKIK
DDDDLDLLLDDLLLLDDDLDDLDLDL
Read the RS-232 interface selection code:
3.
RS-232
AMHKHMFOHNGNENEIEPANHOGOCK
AGPEPJAMDKEOFMHMLJAKFEHFKK
AMGNPJCJGIIJCMCEGJMHNDOLLK
AIFBJLBGMHPLNKECPCGMBBIBOK
AAPHBAJJDAAGMGKDDAOHBGGLHK
AEKFBONJCDDIECLFJIJKMCHLIK
DLDDLDLDLLDLLLLDLLDDDLDLLL
4.
Power up your PC.
1
2
3
RS-23
2 is the default interfac
e set at the factory.
12
To Next Page
Loading...
Need help?
General
