Bluetooth-Only Features Enter/Exit Programming Mode
Product Reference Guide
221
BLUETOOTH-ONLY FEATURES
The features following in this section are valid only for QuickScan Bluetooth models. Also refer-
ence the Setup section for instructions on Linking a BT Reader to a PC, starting on page 16.
RF ADDRESS STAMPING
These features allow configuration of source radio data inclusion.
Source Radio Address Transmission
Enables/disables the ability of source radio address information to be transmitted to the host
and, if so, at what position with respect to the label data. See page 262 in “References” for
detailed information and examples for setting this feature.
Source Radio Address Transmission = Do Not Include
Source Radio Address Transmission = Prefix
When included as a prefix, the source-radio ID is displayed after all label formatting
has been applied. The 6 byte hex address is sent as 12 ascii characters, i.e., an address
of 00 06 66 00 1A ED will be sent as (shown in hex): 30 30 30 36 36 36 30 30 31 41 45 44
To Next Page
Loading...
Need help?
General
