To Next Page

To Previous Page

ENTER/EXIT PROGRAMMING MODE RS-232/USB-COM INTERFACES

QUICKSCAN™ 2500

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK character from the

host following label transmission. The selectable timeout range is 200 milliseconds to

15,000ms (15 seconds) in 200ms increments. A selection of 0 disables the timeout. See

ACK NAK Timeout Value" on page 265 for more detailed programming instructions.

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label transmission due to

a retry condition. The selectable range is from 1 to 254 retries. A selection of 0 disables

the count, and a selection of 255 specifies unlimited retries. See "

ACK NAK Retry Count"

on page 266

for more detailed programming instructions.

Select ACK NAK Timeout Value Setting

$CR2AT

To configure this feature, scan the ENTER/EXIT bar

code above, then the bar code at left followed by dig-

its from the Alphanumeric characters in Appendix D

representing your desired character(s). End by scan-

ning the ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL



01 ACK NAK Timeout value is 200ms

Select ACK NAK Retry Count Setting

$CR2AR