ENTER/EXIT PROGRAMMING MODE KEYBOARD INTERFACE
70
QUICKSCAN™ 2500
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The select-
able range for this feature is from 0 to 99 seconds. See "
Intercode Delay" on page 271 for
more detailed programming instructions
Set Intercode Delay
$CKBID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
00 = No Wedge Intercode Delay
To Next Page
Loading...
