Datalogic Skorpio X3 - Page 165

157
Defaults
Scanner
Type
Code
Parameter
Description
I.D.# Accept. Input
Min
Max
Factory
Laser
2D Imager
Decode
Timeout
Defines the
maximum time
the scanner will
remain on without
reading a
barcode. This
value does not
include time spent
with a spot beam
(1D scanner) or
target pattern (2D
scanner)
002D
2 to 40 (step=1)
2 = 500 ms
40 = 10000 ms
20 20 20 √ √
Beeper Volume
Defines the
volume of
decoding sounds.
FF20
0 to 7 = Soft to Loud
8 = lowers the volume
by 1
9 = raises the volume
by 1
7 7 7 √ √
Long Range
Spot Enable
Enable the use of
a spot beam, if
detected.
0001 On or Off Off Off Off √
Long Range
Release Time
Maximum time
laser is on after
trigger release
using Release
Scan spot beam
mode.
0024 1-5 2 2 2 √
Target Release
Time
Maximum time (in
seconds) imager
is on after trigger
release using
Release Scan
target beam
mode.
002A 1-5 2 2 2 √