Datalogic Skorpio X3 - Repair Mode

1 SKORPIO™ X3
84
4
4.8.4 Repair Mode
If the firmware image on your device becomes corrupted, the device will beep twice
and show a blank screen when powered on.
To reinstall the firmware, complete the following steps:
1. On the PC, click Start > Programs > DFU > Datalogic Firmware Utility.
2. From the Communications menu, select WMDC ActiveSync.
3. Click browse (...) and navigate to the file location.
4. Select the current *.wmg file and click Open.
5. Verify that the device is turned on. Insert the device into a powered dock
connected to the host computer.
6. Click Update.
7. DFU will restore the firmware on your device.