CONFIGURATION USING DL.CODE
INSTALLATION GUIDE 25
Backup and Restore Through DL.CODE
DL.CODE allows Backup and Restore to be performed to/from the configuration PC via
file and to the BM100 external storage device inside the CBX500 (both are recom-
mended).
DL.CODE provides complete backup and restor
e functions (Configuration and Environ-
mental parameters):
For
Master Readers in ID-NET Master/Slave networks:
• Backup and Restore functions provide parameter storage of only the Startup Con-
figuration for the Master and all Slaves present in the network.
NOTE
To save on your PC
To save on the CBX
Backup
To perform a Backup, from the DL.CODE Device menu, select Backup to external stor-
age device and f
ollow the procedure; then perform a backup selecting Backup current
Internal Network configurations (to a file on PC) and follow the procedure.
NOTE
After performing the Backup installation is completed. You can check the station perfor-
mance using the DL.CODE Monitor or the Web Monitor.
CAUTION
For Master/Slave networks any other configurations (jobs) stored in the
device memory will not be backed up. Therefore, all jobs other than the
startup configuration will be overwritten (erased) upon a restore. It is
strongly recommended to save all configurations to backup files.
Before executing a Backup to a BM100 backup module make sure the
Write Protection switch is set to Unlocked.
After executing the Backup to the BM100 module, make sure to lock the
Write Protection switch.
To Next Page
Loading...
Need help?
General