Enter/Exit Programming Mode Set Global Mid Label ID Character(s)
64
Touch TD1100
Set Global Mid Label ID Character(s)
Specifies a mid-label ID that is added for transmission between the labels of a two label pair.
The expected string is a maximum of 20 characters. When combining two label pairs into a
single label for transmission to the host, this label ID can be added to the data, following the
first label and preceding the second label. See "Set Global Mid Label ID Character(s)" on
page 270 for more detailed programming instructions.
$CN2MI
Set Global Mid Label ID Character(s)
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
No Global Mid Label ID
Character(s)
00000000000000000000
00000000000000000000
To Next Page
Loading...
