Appendix B – Internal Menu 41
21) HEAT
Controls the ‘burn-time’ of the printhead. This is
the equivalent of Heat Setting on most label
software programs.
Possible Values:
Range: 0 – 30; default = *10
22) IMAGING MODE
This command instructs the printer whether to pre-
image the label format:
Possible Values:
* Multiple label (The printer images multiple labels
as memory permits, achieving the
fastest throughput; however, if time
stamping, the time will reflect the
moment the label is imaged rather
than when actually printed.)
Single label (The printer images the next label
only after the previous label has
been successfully printed. Single
processing provides time-stamps
that are more accurate, but it slows
label throughput time.)
23) FAULT HANDLING
When a fault condtions is detected, printing stops
and the ERROR light turns on. After the problem is
corrected, the FEED Key must be pressed to clear
the fault. The label in process is not reprinted.
Possible Values:
YES or NO; default = *NO
(NO = NO REPRINT” disabled, reprinting will
occur.)
24) HEAT COMMANDS
This command causes the printer to ignore DPL Heat
commands; instead, the Heat value is controlled via
the menu setting.
Possible Values:
* ENABLED
DISABLED
25) SPEED COMMANDS
This command causes the printer to ignore DPL
speed commands; instead, speed values are
controlled via the menu setting.
Possible Values:
* ENABLED
DISABLED
All of the menu items listed in the previous section are stored in non-volatile memory.
To Next Page
Loading...
Need help?
General