Datamax Mark II E-4205e

46 Appendix B – Internal Menu
+
Problem Possible Cause Solution
Tear Mode is
selected but the
label stop position
(present position) is
not far enough
forward.
Another present
position has been
determined. Enabling
the Present Sensor
causes the label stop
position (present
position) to be
approximately 0.1”
behind the peel bar.
~OR~
The Present Adjust
value is not correct.
 Disable the Present Sensor.
~OR~
 Ensure the host computer is not providing a Present Distance
shorter than is required for the Tear Bar.
 Use the Setup Menu to modify the Present Adjust value.
Tear Mode is
selected but the
label stop position
(present position) is
too far forward.
Another present
position has been
determined.
~OR~
The Present Adjust
value is not correct.
 Ensure the host computer is not providing a Present Distance longer
than is required for the Tear Bar.
 Use the Setup Menu to modify the Present Adjust value.
The FAULT Indicator
illuminates during
label alignment.
The label supply is
empty
 Load media.