Davey Spa Power SP800

5
1.3 LED Indicators
Auto (Non-24HR circ model) This LED is green when automatic control is enabled and off when
pump 1 is under manual control. In automatic “PUMP AUTO” pump 1 runs as required to heat the pool
and ensure minimum ltration times are met. If the indicator is blinking it means that the water sensor
is not detecting any water in the heater housing. If no water is being detected the LCD Display will also
show “WATER PRIMING, PLEASE WAIT”.
Water (24HR circ model) This LED is green when water is detected. If the indicator is blinking it
means that the water sensor is not detecting any water in the heater housing. If no water is being
detected the LCD Display will also show “WATER PRIMING, PLEASE WAIT”.
Auto Icon / Water Icon
Heater This LED shows when the heater is on. The heater will turn on and off as required whenever
the pump is running.
Heater Icon
Sleep This LED is on whenever the controller is within a designated sleep period. When the controller
is asleep the LED is green but the LED colour will change to orange if manually awoken.
During the sleep state the LCD Display will also show “SLEEPING, PRESS ANY KEY”.
Sleep Icon
Ozone This LED is green whenever the ozonator (if tted) is on. Pressing any touch pad button may
automatically turn off the ozonator (depending on installer conguration). If this occurs, the ozonator
will not switch back on until approximately 30 minutes after the last touch pad button press.
Ozone Icon