dbx 160XT - Output Cable Considerations

26
Installation Considerations
Output Cable Considerations
FROM 160)(! TO NEXT DEVICE FROM 160Xl
TO NEXT DEVICE
2
i'
,
--
--
- - -
--
-~
' 1
2
3
I
3
---- - - --- - -
I I
I
.71
lQ..JWE FOM U CONNECT F NE!lltD TO 111:DUCE HUM Xl•M'E MALE
lQ..J\'PE FOMU
/I
CONNECT F NE!lltD 10 REDUCE ~ M
FEMALE XL-TYPE TO MALE XL-TYPE FEMALE XL-TYPE TO STEREO PHONE PLUG
Figure 19: Output Connections (Balanced Lines)
Connect Audio Outputs
The model 160XT has two seperate outputs: one single-ended amplifier driving the 1/4" stereo phone jack,
and a separate active-balanced amplifier driving the XL-type output connecto r. Each is capable of drivin g a
600 ohm load to +24dBu. The XL-type output (balanced) can be transformer-coupled by installing an op-
tional output transformer inside your 160XT (see page 28).
Installation Considerations
FAO" 160(1 10 NEXT Dev>C!
<._..]._I _.....,(} : : 0 --------o : : {]1-_ _,1.._.lt>
MONO PHONE PLUG TO MONO PHONE PLUG
FAOM 160)(1 TO NOO OEVO
I ID
CONNEC1 IF NEElltD TO AEOUCE HUM
MONO PHONE PLUG TO STEREO PHONE PLUG
FROM 161>CT 10 NEXT DEVICE
<.,,..:I .... 1 __ (}: : -o------D :cf[] ,
MONO PHONE PLUG TO PHONO PLUG
dbx l60XT
FROM 101
10 NOO DEVICE
<JI 1
[}i i I O ----0 : : {]1-_ _,1.._.t>
STEREO PHONE PLUG TO MONO PHONE PLUG
f QOM lt:OXT
<::11 I
10 NEXT OEVICt
[}! 0------0 !i{] I ID
'
,l'
00NNEC1 F NEEDED 10 q(OUC( HUM
STEREO PHONE PLUG TO STEREO PHONE PLUG
FqQM 160)(1 10 NOO OEVQ
<)I I
STEREO PHONE PLUG TO PHONO PLUG
Figure 20: Output Connectio ns (Unbalanced Lines)
27