Dea Spazio Series - Installation, Assembly, and Disassembly; Adjustment Procedures; Maintenance and Repair; Trouble-Shooting

S P A Z I O
Operatinginstructionsandwarnings
12
“TROUBLE-SHOOTING” table
MALFUNCTION CAUSES / SOLUTIONS
When the opening or closing
command is activated the gate
leaf fails to move and the opera-
tor’s electric motor fails to start.
The operator is not appropriately powered; check all connections, fuses and power supply
cable conditions and replace or repair if necessary. If the door does not close check that
photocells work appropriately.
When the opening command
is activated, the motor starts
but the door fails to move
Make sure that the motor does not push in the opposite direction, the limit switch electrical
connections might be reversed
The gate moves by fits and
starts, it is noisy, it stops at
half run or it does not start
The door does not move smoothly; unlock the motor and eliminates any obstacle from
rotating points.
The operator force might be insufficient for the door features; make sure the chosen ope-
rator model is fit.
ensureproperworkingSPAZIOmustbesuitably positionedin
relationtothedoor.DEASystemrecommendedmeasuresare
showninF3p.45.Theoperatormustbechosenaccordingto
thedoortoautomateandslidingproperties,weightandwidth/
heightofthedoormustbeassessed.elementstobeconsidered.
WARNINGTheuseoftheproductunderunusualcondi-
tionsnotforeseenbythemanufacturercancreatesituations
ofdanger,andforthisreasonalltheconditionsprescribedin
theseinstructionsmustberespected.
4.5 Instructions for risk-free operation
4.5.1 Transport
TheSPAZIOgateoperatorisalwaysdeliveredpackedinbo-
xesthatguaranteetheproductadequateprotection.Carefully
readanywarningsorinstructionsforstorageandhandlingpro-
videdonthebox.
4.5.2 Installation,assemblyanddisassembly
Forasatisfyinglayingoftheproductitisimportanttodefinethe
entireautomaticopeninglayout(seealso“Completeclosingas-
sembly”);morespecifically,afteryouhavecarefullyassessedthe
featuresoftheplace,definemodelandcorrectpositioningand
thenassembleSPAZIO(seeF3page47):
•Fitthescrewsinthealuminium-profileslot
•Join the aluminium profiles with the appropriate connecting
rods(DONOTscrewthenutstoostrongly)
•Fastenthealuminiumguiderailtothemotorbasebyinserting
thecentering“tab”andwrapthechainoverthedraftpinion.
•Putunderlighttensionthechainbyoperatingontheindicated
nutandfastenproperlybyusingthelocknut
•Anchorthemetalbrackettothewallaligningittothecenterof
thedoorbyusingappropriatebushingstoanchorthescrews
andpositioningitatrightheight
•BolttherailtotheceilingbyusingtheM6nutasshimbetween
the aluminium-profile and the metal bracket.  Cut and
discardunusedportionofthebrackets.
•Screworrivetthedraftbrackettothedoorwithappropriate
screws/rivets.
•Adjustlimitswitchcams(seeF4pages45-46),completewiring
(seewiringdiagram)andthenprogramthebuilt-incontrol
boardasspecifiedbelow.
 WARNING All installation, maintenance, cleaning or
repairoperationsonanypartofthesystemmustbeperfor-
medexclusivelybyqualifiedpersonnelwiththepowersupply
disconnectedworkinginstrictcompliance withtheelectrical
standardsandregulationsinforceinthenationofinstallation.
4.5.3 Starting
Theinstallationoftheproductdemandsmasonryand/orwel-
dingandelectricalconnectionoperationsusingadequateequi-
pment for the job in complete respect of accident-prevention
standardsandregulationsinforceinthenationofinstallation.
Ensurethedoortobeautomatedisingoodworkingcondi-
tions,properlycounterbalancedandthatthewholestructureis
solid.Theproductisequippedwithabuilt-incontrolboard:see
itsinstructions.(Seeparagraph5.1and5.2)
4.5.4 Use
Theproductisintendedtobepartofaseriesofequipmentthat
makeupthedoorautomation.DEASystemassumesthatitwill
alwaysbeusedincompliancewiththestandardsandregula-
tionsinuse.
AllSPAZIOmodelsareequippedwithanunlockingsystem:just
turnthereleasehandleinthedirectionshowninF9page48;
nowifnoobstructionshinderitsmovement,thegatecannow
movefreely.Thedoorwillbelockedagainautomaticallywith
thefirsttravelthusreturningtheoperatortoitsnormalworking
conditions.
4.5.5Adjustment
SPAZIOispresetwith limitswitches whoseoperationmust
beadjustedatthejobsite.Inordertoadjustthelimitswitch
camsloosenfixingscrew“B”,andturncams“A(Green)”and
“C (Red)” until their respective micro-switches are activated,
thenfastenscrewsintheirnewposition.(seeF4pages45-46
andfollowtheinstructionsgiveninparagraph5.2).
Otheradjustmentscanbemadedirectlyonthecontrolbo-
ardthatcontrolsdirectlymotorspeedandcanpreservetorque
evenwhenoperatingatlowrate,itcancontroldurationofany
slowdownspeedthatmayhavebeenselectedandanti-crush
safetysensibilityaswellasotherparametersasdescribedinpa-
ragraphs5.1and5.2.
 WARNING To avoid premature failureofthe operator
program the control board appropriate slow down speed.
4.5.6 Maintenanceandrepair
Goodpreventivemaintenanceandregularinspectionensure
longworkinglife(seealso“Warranty”).Consultthe“TROUBLE-
SHOOTING”tablewheneveranomaliesareobservedinorder
tofindthesolutiontotheproblemandcontactDEASystemdi-
rectlywheneverthesolutionrequiredisnotprovided.
Theinspection/maintenanceoperationstoberoutinelysche-
duledinthe“completeautomatismmaintenanceregister”are:
INTERVENTIONTYPE PERIODICITY
Chain and rotating joints lubrication 6 months
Check screws screwdown 6 months
Check chain tension 6 months
 WARNING All installation, maintenance, cleaning or
repairoperationsonanypartofthesystemmustbeperfor-
medexclusivelybyqualifiedpersonnelwiththepowersupply
disconnectedworkinginstrictcompliancewiththeelectrical
standardsandregulationsinforceinthenationofinstallation.