DSE Model 8620 AMF Controller Operators Manual
57
5.2.1 STATUS
This is the ‘home’ page, the page that is displayed when no other page has been selected, and the
page that is automatically displayed after a period of inactivity (LCD Page Timer) of the module control
buttons.
This page will change with the action of the controller , when on gen generator parameters will be seen
and when changing to mains the mains parameters will be shown.
Status 22:31
Status 22:31Status 22:31
Status 22:31
Factory setting of Status screen showing engine stopped...
Generator at Rest
Generator at RestGenerator at Rest
Generator at Rest
Stop Mode
Stop ModeStop Mode
Stop Mode
Safety on Delay
Safety on Delay Safety on Delay
Safety on Delay
00:04
00:0400:04
00:04
...and engine running
L
LL
L-
--
-N 215V 4
N 215V 4N 215V 4
N 215V 43A
3A3A
3A
L
LL
L-
--
-L 373V
L 373V L 373V
L 373V
47.5Hz
47.5Hz47.5Hz
47.5Hz
0kW
0kW 0kW
0kW
0.0pf
0.0pf0.0pf
0.0pf
The contents of this display may vary depending upon configuration by the generator manufacturer /
supplier.
The display above is achieved with the factory settings, shown below in the DSE Configuration suite
software:
NOTE:- The following sections detail instrumentation pages, accessible using the scroll
left and right buttons, regardless of what pages are configured to be displayed on the ‘status’
screen.
‘Stop Mode’ etc is
displayed on the
Home Page
With a summary of the
instrumentation shown when
the engine is running.
Other pages can be configured to
be shown, automatically scrolling
when the set is running.
To Next Page
Loading...
