6 Maintenance and Service 15
Do not inform the software that the battery has been changed no new battery was
installed. Otherwise this can lead to lose the saved firing programs and software.
Do not throw away used batteries, but dispose of them as prescribed by law.
6.5 REPLACING THE HEATING ELEMENT
Over time, the heating element wears out from use. This can have a negative
influence on your firing results. For this reason, change the heating element at the
proper time. If the self-check program is run regularly (Section 7.6.2) a
recommendation will be displayed when the heating element wear has exceeded
the permissible limit. Follow the accompanying installation and safety instructions in
Section 4 to install the replacement heating element.
Only authorized personnel may perform technical work. (see p. 15)
TIP B
see p. 42
6.6 SERVICE AND TRANSPORT
We recommend regular maintenance of the equipment by your service partner. This
will ensure superior firing results.
If you need to replace wearing parts or want to update the set programs, please
consult the responsible service partner. If more extensive repairs to the furnace or
pump are required, please also contact your service partner. Please direct any
questions for the manufacturer to the following address:
DEKEMA Dental-Keramiköfen GmbH
Industriestraße 22
D-83395 Freilassing
Phone +49-(0) 86 54 / 46 39-0
Fax +49-(0) 86 54 / 6 61 95
E-mail info@dekema.com
Homepage http://www.dekema.com
When transporting the furnace and/or the pump, please use the original cardboard
box and packaging.
Please proceed as follows when packing the equipment,:
• Note that the device needs several hours to cool down (see p. 8).
• Close the firing chamber.
• Turn off the device and pull the pump plug.
• Only use the original box and the supplied packaging material.
6.7 REPLACEMENT PARTS
Only use original DEKEMA parts for servicing and maintaining the oven. Contact
your service partner, or contact DEKEMA directly.
DEKEMA Dental-Keramiköfen GmbH, AUSTROMAT
®
D4, Version 3, 2006