V0413, 10
To access the System information screen place the cursor on
the System information screen parameter and press the enter
key. In the service information screen the following information is
viewed.
Calibration point
Refer to chapter 4 for details
System information screen
Software version: the version num-
ber of the installed application soft-
ware of the DA-41. This parameter is
read-only.
Serial number: the serial number of
the DA-41. This parameter is read-
only.
Memory usage: indicated how many
percent of the available memory is
used. This parameter is read-only.
Hours: the number of hours the
machine has been running. This
parameter is read-only.
Strokes: the number of bend strokes
the machine has executed. This
parameter is read-only.
Material properties menu:
In this menu the material properties
can be programmed. To access the
menu press the enter key, to exit
press the STOP button
To Next Page
Loading...