V0413, 24
A maximum of 25 bends can be programmed.
For quick programming:
• Put the cursor on the angle or Y-axis parameter
• Type the required value and press ENTER: the cursor auto-
matically jumps to the backgauge parameter
• Type the required value and press ENTER
• Repeat these steps for other bend steps
Use the arrow keys to move to a specific parameter. In order to
add a new bend place the cursor to the first column (bend
number) and press ENTER. To Delete a bend place the cursor
to the first column (bend number) and press CLEAR button.
4.4.2 Program edit
Beside the possibility to change all the parameters in the pro-
gram, it is also possible to add or remove bend steps from an
existing program.
To add a bend to the program:
Go to the last bend of the current program, move the cursor to
the first column (bend number) and press ENTER. A new bend
is added, which has the same parameter values as the previous
bend.
To insert a bend to the program:
Select the number of the bend step after which a step should be
inserted. Press the ENTER key; a copy of the selected bend
step will be inserted. The cursor will automatically move to the
new bend step.
Digital function output. The value pro-
grammed will be active during the bend
step.
The availability of this parameter is depend-
ing on machine settings.
To Next Page
Loading...