Delem DA-41 - Page 27

Delem
V0413, 23
Y-axis bend depth.
When an angle is programmed, this value
is calculated. A higher value means a lower
beam position.
Angle correction on the Y-axis.
When angle programming is used, this cor-
rection is used to correct Y-axis values. A
positive correction means a lower beam
position.
Y-axis opening time.
The required opening time after a bend,
programmed as a percentage of the maxi-
mum opening time. The availability of this
parameter is depending on machine set-
tings.
Beam high speed yes/no (1/0).
Select high travel speed for the beam dur-
ing this bend, yes or no. The availability of
this parameter is depending on machine
settings.
Back gauge position.
The required back gauge position for this
bend.
Bending Force.
In this field the calculated bending force is
shown. The availability of this parameter is
depending on machine settings.
Retract distance of the back gauge.
The availability of this parameter is depend-
ing on machine settings.
Delay time in seconds for X-axis and FD
axis after a step change.
The availability of this parameter is depend-
ing on machine settings.