Figure 90. Removing the accelerator card from riser 1B
4. Install a filler bracket if you are not replacing the expansion card. For information about how to install a filler bracket, see installing a
filler bracket section in the Removing the expansion card topic.
Next steps
1. Install an accelerator card.
Installing an accelerator card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 43.
2. Follow the procedure listed in the Before working inside your system on page 44.
3. If installing a new expansion card, unpack it and prepare the card for installation.
NOTE: For instructions, see the documentation accompanying the card.
4. Install the air shroud.
Steps
1. Pull and lift to open the expansion card retention latch lock.
2. If installed, remove the filler bracket. For information about how to remove filler bracket, see the removing a filler bracket section in
the Installing an expansion card topic.
3. Hold the card by the edges, align with the connector on the expansion card riser and press until the card is seated in place.
Installing and removing system components
105
To Next Page
Loading...
