Installing and removing system components
Topics:
• Safety instructions
• Before working inside your system
• After working inside your system
• Recommended tools
• Cable routing
• Optional front bezel
• System cover
• Drive backplane cover
• Air shroud
• Cooling fan
• Intrusion switch module
• Drives
• Drive backplane
• Rear drive cage
• System memory
• Processor and heat sink
• Expansion cards and expansion card risers
• M.2 SSD module
• Optional IDSDM module
• Micro SD card
• LOM riser card
• Storage controller card
• System battery
• Optional internal USB memory key
• Optional optical drive
• Power supply unit
• Power interposer board
• System board
• Trusted Platform Module
• Control panel
Safety instructions
NOTE: To avoid injury, do not lift the system on your own, get others to assist you.
WARNING: Opening or removing the system cover while the system is turned on may expose you to a risk of electric
shock.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
CAUTION: To ensure proper operation and cooling, all bays in the system and system fans must be always populated
with a component or a blank.
NOTE: It is recommended that you always use an antistatic mat and antistatic strap while working on components inside
the system.
5
Installing and removing system components 43
To Next Page
Loading...
