Figure 49. Removing the drive backplane
3. Disconnect the following cables from the backplane:
a. Backplane signal cable
b. Backplane power cable
c. If applicable, PERC cable
Next steps
1. Replace the drive backplane.
Installing the drive backplane
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 43.
2. Follow the procedure listed in the Before working inside your system on page 44.
3. Remove the drives.
4. If applicable, remove the drive backplane cover.
NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Connect the following cables to the backplane:
a. Backplane signal cable
b. Backplane power cable
c. If applicable, PERC cable
2. Align the slots on the backplane with the hooks on the chassis.
Installing and removing system components
69
To Next Page
Loading...
