Table 7. Rear view of the system with no rear drives (continued)
Item Ports, panels, or slots Icon Description
9 Ethernet ports (2) The Ethernet ports that are integrated on the system board provide
network connectivity. These NIC ports can also be shared with iDRAC
when iDRAC network settings is set to shared mode. For more
information about the supported configurations, see the Technical
Specifications section.
10 USB 3.0 port (2) These USB ports support USB 3.0.
11 iDRAC dedicated port
Enables you to remotely access iDRAC. For more information, see the
iDRAC User’s Guide at www.dell.com/poweredgemanuals.
12 VGA port Enables you to connect a display device to the system. For more
information, see the Technical Specifications section.
13 System status indicator
cable port (CMA)
N/A Enables you to connect the status indicator cable and view system
status when the CMA is installed.
14 System identification button Press the system ID button:
• To locate a particular system within a rack.
• To turn the system ID on or off.
To reset iDRAC, press and hold the button for 16 seconds.
NOTE:
• To reset iDRAC using system ID, ensure that the system
ID button is enabled in the iDRAC setup.
• If the system stops responding during POST, press and
hold the system ID button (for more than five seconds) to
enter the BIOS progress mode.
For more information about the ports and connectors, see the Technical Specifications section.
System overview
15
To Next Page
Loading...
