NOTE: The antenna and cables are a part of the speaker assembly.
Installing the speaker assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: The wireless antennas are attached to the speakers as an assembly and cannot be separated for individual
replacement. When the speakers or the wireless antennas need to be replaced, services will dispatch both the speaker
assembly as a single serviceable component.
The following image indicates the location of the speaker assembly and provides a visual representation of the installation
procedure.
Figure 35. Installing the speaker assembly
Removing and installing Field Replaceable Units (FRUs)
59
To Next Page
Loading...
