Dell Alienware Aurora R11 - Front Alienfx LED Boards; Removing the Front Alienfx LED Board; Installing the Front Alienfx LED Board

Front AlienFX LED boards
Removing the front AlienFX LED board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the right-side cover.
4. Remove the top-cover.
5. Remove the front bezel.
About this task
The following images indicate the location of the front AlienFX LED board and provides a visual representation of the removal
procedure.
Steps
1. Disconnect the AlienFX LED board cable from a Y-cable.
2. Remove the four screws (M3x4) that secure the AlienFX LED board to the front bezel.
3. Lift the AlienFX LED board off the front bezel.
Installing the front AlienFX LED board
Prerequisites
Ha valamelyik alkatrész cseréjére van szükség, távolítsa el az eredetileg beszerelt alkatrészt, és ezt követően végezze el a
beszerelési eljárást.
About this task
The following images indicate the location of the front AlienFX LED board and provides a visual representation of the installation
procedure.
88
Alkatrészek eltávolítása és beszerelése