Dell B5460dn - Additional Printer Setup; Installing Internal Options

Additional printer setup
Installing internal options
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and then unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then
turn them off as well, and unplug any cables going into the printer.
Available internal options
Note: Some options are available only in select printer models. For more information, contact the place where you
purchased your printer.
• Memory card
– DDR3 DIMM
– Flash memory
• Fonts
• Firmware cards
– Forms and Bar Code
– PRESCRIBE
– IPDS
• Printer hard disk
• Internal Solutions Ports (ISP)
Accessing the controller board
Note: This task requires a flat‑head screwdriver.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
1 Remove the controller board access cover.
1
2
Additional printer setup 13