Setting up the monitor | 23
Inserting the batteries in the remote control
The remote control is powered by two 1.5 V AAA batteries.
To install or replace batteries:
1.
Press and then slide the cover to open it.
2.
Align the batteries according to the (+) and (–) indications inside the battery
compartment.
3.
Replace the cover.
CAUTION: The incorrect use of batteries can result in leaks or
bursting. Be sure to follow these instructions:
• Place “AAA” batteries matching the (+) and (–) signs on each battery to the
(+) and (–) signs of the battery compartment.
• Do not mix battery types.
• Do not combine new batteries with used ones. It causes shorter life or
leakage of batteries.
• Remove the dead batteries immediately to prevent them from liquid leaking
in the battery compartment. Do not touch exposed battery acid, as it can
damage your skin.
NOTE: If you do not intend to use the remote control for a long period,
remove the batteries.
To Next Page
Loading...
