Table 12. — Boot
Boot List Option Displays the boot modes
Default: UEFI
File Browser Add Boot Option and File Browser Del Boot
Option are actiavted
Secure Boot Allows you to enable or disable the Secure Boot control.
Default: Enabled
Legacy Option ROMs Allows you to load the legacy option ROMs.
Default: Disabled
Boot Option Priorities Enables you to change the boot option priorities.
Table 13. — Exit
Save Changes and Reset Allows to save or rest the changes made to the system setup.
1. Allows you to discard the changes made to the system
setup.
2. Allows you to restore the system setup options to default.
3. Allows you to discard the changes made to the system
setup.
4. Allows you to save the changes made to the system setup.
Topics:
• System Setup overview
• Accessing System Setup
• System setup options
System Setup overview
System Setup allows you to:
● Change the system configuration information after you add, change, or remove any hardware in your computer.
● Set or change a user-selectable option such as the user password.
● Read the current amount of memory or set the type of hard drive installed.
Before you use System Setup, it is recommended that you write down the System Setup screen information for future
reference.
CAUTION:
Unless you are an expert computer user, do not change the settings for this program. Certain
changes can cause your computer to work incorrectly.
Accessing System Setup
1. Turn on (or restart) your computer.
2. After the white Dell logo appears, press F2 immediately.
The System Setup page is displayed.
NOTE:
If you wait too long and the operating system logo appears, wait until you see the desktop. Then, shut down or
restart your computer and try again.
NOTE: After the Dell logo appears, you can also press F12 and then select BIOS setup.
44 System Setup Options
To Next Page
Loading...
