Table 5. System setup options—Advanced menu (continued)
Advanced
IPv6 HTTP Support Allows you to enable or disable IPv6 HTTP Support.
Default: Disabled
USB Configuration
Front USB Ports Allows you to enable or disable the Front USB ports.
Default: Enabled
Rear USB Ports Allows you to enable or disable the Rear USB ports.
Default: Enabled
Power Options
Wake Up by Integrated LAN Allow the computer to be powered on by special LAN signals.
Default: Disabled
AC Recovery Sets what action the computer takes when power is restored.
Default: Power Off
Deep Sleep Control Allows you to define the controls when Deep Sleep is enabled.
Default: Enabled in S4 and S5
USB Wake Support Allows you to enable the USB devices to wake the system
from Standby.
Default: Enabled
USB PowerShare in S4/S5 state Allows you to charge external devices.
Default: Disabled
USB PowerShare in Sleep State Allows you to enable front the USB devices to wake the
system from sleep state.
Default: Normal
Auto Power On Allows you to enable or disable Auto Power On.
Default: Disabled
Auto Power On Mode Allows you to set the computer to turn on automatically every
day or on a preselected date. This option can be configured
only if the Auto Power On mode is set to Enabled Everyday or
Selected Day.
Default: Selected Day
Auto Power On Date Allows you to set the date on which the computer must turn
on automatically. This option can be configured only if the Auto
Power On mode is set to Enabled 1 to 31.
Default: 15
Auto Power On Time Allows you to set the time at which the computer must turn
on automatically. This option can be configured only if the Auto
Power On mode is set to Enabled hh:mm:ss.
Default: 12:30:30
Numlock Key Allows you to set the status of the Num Lock key during boot
to On or Off.
Default: Enabled
Performance Options
Overclocking Feature Allows you to enable or disable the Overclocking Feature.
System setup 67
To Next Page
Loading...
