90 Removing and Installing Parts
5
Insert the new battery into the socket with the side labeled "+" facing up, and snap the battery into
place.
6
Replace the computer cover (see "Replacing the Computer Cover" on page 90).
NOTICE: To connect a network cable, first plug the cable into the network port or device, and then plug it into the
computer.
7
Connect your computer and devices to electrical outlets, and then turn them on.
8
Enter system setup (see "System Setup" on page 97) and restore the settings you recorded in step 1.
9
Properly dispose of the old battery. See the
Product Information Guide
for battery disposal information.
Replacing the Computer Cover
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
1
Ensure that all cables are connected, and fold cables out of the way.
Gently pull the power cables toward you so that they do not get caught underneath the drives.
2
Ensure that no tools or extra parts are left inside the computer.
1 battery 2 battery socket
2
1
To Next Page
Loading...
Need help?
General