84 Removing and Installing Parts
12
Close the card retention door by snapping it into place to secure the cards.
13
Connect any cables that should be attached to the card.
See the documentation for the card for information about the card’s cable connections.
14
Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn
them on.
15
If you installed a sound card:
a
Enter system setup (see "System Setup" on page 115), go to
Onboard Devices
and select
Integrated Audio
, and then change the setting to
Off
.
b
Connect external audio devices to the sound card’s connectors. Do not connect external audio
devices to the microphone, speaker/headphone, or line-in connectors on the back panel. See "Back
Panel Connectors" on page 16.
16
If you installed an add-in network adapter and want to disable the integrated network adapter:
a
Enter system setup (see "System Setup" on page 115), go to
Onboard Devices
and select
Integrated NIC
, and then change the setting to
Off
.
1 alignment guide 2 alignment bar 3 release tab
4 card retention door
2
4
3
To Next Page
Loading...
